6.4L AND 6.0L FORD POWER STROKE INSTALLATION

FRAME MOUNT INSTALLATION AND “UNDER THE HOOD” DETAILS

Change stock oil filter and oil, replacing old oil filter cap with new billet cap:

Install elbow fitting 2MP-6MJ into New Billet Oil Filter Cap w/swivel port. Carefully transfer old oil filter cap o-ring to new billet Oil Filter Cap if a new one is not supplied. Install new stock oil filter element into new cap, being sure it snaps in. Screw new oil filter cap and filter onto the engine. Add engine oil to spec.

Install elbow fitting securely into supplied ported Billet Oil Filler Cap using thread sealer or Teflon tape. Remove stock oil filler cap and install supplied ported Billet Oil Filler Cap.

Install the EXTREME Filter housing hose adapter fittings into both the “IN” and “OUT” ports using thread sealer or Teflon-tape as firmly and deeply as possible. Watch this video for prep information: 

Typical Mounting Locations:

Install EXTREME Filter into bracket using supplied hardware as pictured above.

Install 5’ line(hose) and route from stock oil filter housing “T” to “IN” port (center most port) fitting on bottom of theEXTREME Oil Filter housing. Remember to avoid sharp edges, hot surfaces, and moving parts and leaving a little slack for engine movement when routing the hose.

Install 7’ line on EXTREME Filter housing “OUT” port fitting (nearest edge of filter) and route to new Oil Filler Cap, avoiding sharp edges, hot surfaces, and moving parts. Use ties as necessary to secure safely.

“Under the Hood” Mount Location

Watch this installation video for additional information